home *** CD-ROM | disk | FTP | other *** search
- PrimoPyro1990
-
-
-
-
- ... TEARGAS AND RELATED ITEMS ...
-
-
- DISCLAIMER: This file contains information on making substances which are
- illegal or harmful. Neither the BBS carrying this file nor its
- author can be considered responsible for making this information
- available. This file is intended for information only.
-
-
-
- CAPSTUN: Capstun (capsaicin) is the active oil in red pepper. If you don't
- think something derived from pepper can be as good as CN or CS tear gas,
- think. Even if a person is maced, he can still can still function if he is
- motivated enough. Capstun is an irritant which causes nasal passages to swell
- , making the affected person breathe through their mouth which in turn causes
- them to inhale the capstun which affects the throat causing choking. It's
- effect in the eyes is extreme tearing and pain. In addition it causes a
- burning sensation on any exposed skin. Capstun does not cause permanent
- damage.
- Capstun is easy to make. The only drawback is you have to heat up ethyl
- alcohol which is flammable.
- Obtain 1 lb. of dried red or green hot peppers. The hotter the better. Chop
- them up in a blender and put them into a large jug. Add denatured ethyl
- alcohol to the peppers until they are covered by an inch or two of alcohol.
- Put the jug into a pot of water on an electric burner and bring the alcohol
- almost to a simmer. Be very careful as the alcohol fumes can ignite. Don't
- use a flame to heat the water. Let the alcohol cool a bit then filter it off.
- Repeat this 3 times. Throw out the peppers and put all the alcohol into a
- large mouthed jar. Take the water pot/heater outside and heat up the alcohol.
- Evaporate the alcohol down to about 100 mls. Filter off the alcohol again
- and let it evaporate to leave a thick reddish oil. If you are adventurish
- take a minute amount of the oil and taste it. Have plenty of water on hand
- though.
- Capstun is usually used as a 1% to 5% solution. Cut it down with mineral oil
- or another suitable carrier.
- CAPSTUN BOMB: Take a 12 gauge shotgun shell and open the crimp. Pour out the
- shot and seal the shot cup with a thin layer of epoxy. The seal must be oil-
- proof. Take a 1 in. long piece of broomhandle and drill a small hole through
- it's center. Epoxy it onto the brass end of the shell so that the hole is
- over the primer. Now fill the shell with a 5% solution of capstun. Close the
- crimp up again and epoxy the end shut. Take a cloth streamer about 1 1/2 in.
- wide by 2 ft. long and epoxy one end of it to the crimp end of the shell.
- When all is ready take a short nail and insert it through the hole up against
- the primer. Hold it in place with 2 pieces of tape. To use this, fold the
- streamer up in your palm and place the shell on top of the streamer. Throw
- the shell in a high arc. The streamer will cause the shell to land nail end
- first setting off the primer. When the shell goes off it will spray the
- capstun into the air. Two of these can clear the street.
- If you have problems with the capstun leaking, try loading it first into a
- small plastic bag. Heat seal the open end of the bag then load it in the
- shotgun shell without the shot cup.
- Even though the capstun won't cause damage, the carrier it is dissolved in
- can, so chose it carefully.
-
-
-
- *** Kilroy was here ***
-